Conrad GX103+GPS Betriebsanleitung PDF herunterladen (Seite 30)

Deleting data:

To delete all data and release the memory for new recordings, the follwong command is used:

RESET TRACKDATA #1513

e) Programming the GPS Zone (Command “GPSZONE”)

The product may be used for zone monitoring. After programming of the permitted zone (max. 10) and after activation of the alarm mode

(“ENABLE”), every time the permitted zones are exceeded will cause an alarm message with the current GPS coordinate to be sent to all phone

numbers stored.

Use the following command to programme the zones:

SET GPSZONE < latitude 1><longitude 1><latitude 2><longitude 2> #1513

Latitude 1 = upper threshold (towards North)

Latitude 2 = upper threshold (towards South)

Longitude 1 = left threshold (towards West)

Longitude 2 = right threshold (towards East)

The following example shows the data input format:

Latitude – gg.gggggg N (degrees), e.g.: 49° 59,5058’ N = 49.991763 N

Longitude – ggg.gggggg E (degrees), e.g.: 11° 57.0399’ E = 011.950665 E

Observe that missing digits are filled in with “0”.

Example: 3° 3.23’ E = 003.032300 E

The GPS coordinates are indicated in degrees and minutes with six decimal digits in the product. Data input is possible in the range of xx.000000°

to xx.999999°.

The command for zone monitoring must be entered, e.g., as follows:

SET GPSZONE 49.549680N 011924780E 49.537480N 011.957910E #1513

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Keine Kommentare

Conrad GX103+GPS Betriebsanleitung Seite 30